N2 CO2 Compressor
Machinery Manufacturing/333912 -- Air and Gas Compressor Manufacturing

System must be capable of compressing/boosting 99% N2/CO2 without using oil. System must be capable of being supplied with w/2000 PSI N2 cylinders and provide 3000 PSI at supply point. All parameters must be able to be met while at 4295 ft above sea level with temperature fluctuations of -10 degrees to 110 degrees Fahrenheit depending on the season. Must use existing  electrical supply for system which is 3 phase 115 VAC 150 Watts. Usage of the pump is intermittent approximately 5 hours a day 10 minutes to 60 minutes off with 10 minutes to 30 minutes on.
Other requirements are:
20 micron filter
Moisture and oil separator
Capable of adding 3.06 lbs co2 and 5.7 lb n2 to a bottle has to be capable to service at least 3,000 psi rate of charge for co2 is not to exceed 0.05lb/sec rate of charge for n2 is not to exceed 50 psig per sec
Can be 2 separate pumps

Contracting Office Address:
110 E. Alison Ave
Cannon AFB, New Mexico 88103-5321 
United States 
Place of Performance:
118 E. Alison Ave. Bldg 684 Rm 9
Cannon AFB, New Mexico 88103 
United States 
Primary Point of Contact.:
John M. Takats
john.takats@us.af.mil
Phone: 5757842815
Secondary Point of Contact:
Paul F. Aramanda
paul.aramanda@us.af.mil
Phone: 5757846689